Service Mode; Service Mode Setting Procedure; Adf Setting Procedure; Original Stop Position - Konica Minolta bizhub C353 Service Manual

6. Service Mode

6. Service Mode
6.1

Service Mode setting procedure

See P.338 of the main body service manual.
6.2

ADF setting procedure

6.2.1

Original Stop Position

Functions • To manually adjust the original stop position and the read position in each of the ADF
modes.
Use • When the result is Unable in the automatic adjustment of the original stop position.
Setting/
P.40
procedure
6.2.2

Registration Loop Adj.

Functions • To adjust the length of the loop to be formed in paper before the registration rollers.
Use • When an original misfeed or skew occurs.
Adjustment
• The loop value increases by the entered + value and decreases by the entered - value.
instructions
Adjustment • The default setting is 0.
range • Adjustable range: -5 mm to + 5 mm (in 1-mm increments)
1. Call the Service Mode to the screen.
2. Touch [ADF].
3. Touch [Registration Loop Adj].
4. Select either [1-Side] or [Second Side] for the adjustment.
Setting/
5. Press the clear key and change the setting value using the 10-key pad. (Press the [+/-]
procedure
key to change the +/- code.)
6. Touch [END].
7. Touch [Exit] on the Service Mode screen.
8. Turn OFF the main power switch, wait for 10 sec., then turn the switch ON.
6.2.3

Auto Stop Position Adjustment

A. Sub Scanning Direction 1-Side
Functions • To automatically adjust the read position for the Sub Scanning Direction 1-Side.
• To check skew feed.
Use • When ADF has been replaced.
Setting/
P.36
procedure
B. Sub Scanning Direction 2-Side
Functions • To automatically adjust the read position for the Sub Scanning Direction 2-Side.
Use • When ADF has been replaced.
Setting/
P.38
procedure
28
Field Service Ver. 2.0 Jan. 2008