System Settings-Date/Time Settings; System Settings-Daylight Saving Time - Konica Minolta bizhub C360 Service Manual

10. UTILITY
C. Shift Output Each Job
• It will be displayed when the optional finisher FS-527/529 or the job separator JS-505 is
mounted.
(1) Use
• To set whether to offset each job when paper is printed using the finisher.
• Some paper type may fail to be discharged or get deteriorated loading when large vol-
ume copies are printed using the finisher.
This function is used to print large volume copies when finisher is mounted.
(When this function is set to "No", the paper is discharged without offsetting the paper to
the center of the tray.)
(2) Procedure
• The default setting is Yes.
10.6.3

System Settings-Date/Time Settings

A. Use
• To set the date/time and the time zone to start the clock.
• This setting should be carried out for set up.
B. Procedure
• For time zone, set the time difference with the world standard time.
• Setting range for the time zone: -12:00 to +12:00 (by 30 minutes)
• When the following setting is set to "ON", [Set Data] will be displayed. Touch [Set Data]
and modify the time.
[Administrator Settings] → [Network Settings] → [Detail Settings] → [Time Adjustment
Setting]
10.6.4

System Settings-Daylight Saving Time

A. Use
• To set whether to set the daylight saving time.
• To set the time difference in setting the daylight saving time.
B. Procedure
• The default setting is No.
• When setting to ON, set the time difference to move up.
218
"Yes"
Yes
"60 min." (1 to 150)
Field Service Ver. 2.1 Feb. 2012
No
"No"