Konica Minolta bizhub C360 Service Manual page 734

Field Service Ver. 2.1 Feb. 2012
19.5.180 CD3##: NVRAM data error
• When the data stored due to the NVRAM trouble is lost, backup data can be used for res-
toration.
• Trouble code [C-D370] will be displayed when multiple errors (over 5) of NVRAM data
are detected, which can be restored with one restoration command.
• Data backup will be automatically performed every hour. Backup can also be performed
manually with the following setting.
[Service Mode] → [Enhanced Security] → [NVRAM Data Back Up]
See P.512
1. When a trouble caused by NVRAM data error occurs, the screen below appears.
2. Select [Yes] and touch [OK].
3. The screen will be shifted to the data restoration screen to perform data restoration.
NOTE
• When the restoration is performed in a short time, data restoration screen may not
be displayed.
4. Check the message which indicates that the data restoration was successfully con-
ducted. Turn OFF the main power switch and turn it ON again more than 10 seconds
after.
NOTE
• In case it failed to restore data, return to the trouble code screen.
19. TROUBLE CODE
A00JF4E517DA
679