Managed Access Point; Table 9: Managed Access Point Commands - D-Link DWL-6600AP Cli Command Reference

D-Link UAP CLI Command Reference
Action
Set the channel bandwidth.
Set the primary channel.
Set the channel protection.
Set the Beacon interval.
Set the DTIM interval.
Set the fragmentation length threshold.
Set the RTS threshold.
Set the maximum number of clients allowed to
associate (VAP 0 radio 0).
Set the power transmission level (percent).
Set the fixed multicast rate.
Add a basic rate set.
Get current basic rates.
Add supported rate.
Get current supported rates.
Get the current MCS index settings.
Enable an MCS index on a radio.
Disable an MCS index on a radio.
Enable or disable broadcast/multicast rate
limiting.
Set the rate limit (packets per second).
Set the rate limit burst (packets per second).
Set the STBC.
Set the short guard interval.

Managed Access Point

You can use a D-Link Unified Switch to manage one or more access points on your network. To allow a switch
to manage the AP the switch and AP must discover each other. The commands in
the AP mode from Standalone to Managed and how to configure the IP address of a D-Link Unified Switch so
that the AP can discover it. You can configure a pass phrase on the AP and on the switch so that only
authenticated APs can associate with the switch.
Action
View managed AP settings.
D-Link
November 7, 2011
Table 8: Radio Settings Commands (Cont.)
Command
set radio wlan0 n-bandwidth {20 | 40}
set radio wlan0 n-primary-channel {lower | upper}
set radio wlan0 protection {auto |off}
set radio wlan0 beacon-interval 20-1000
set radio wlan0 dtim-period 1-255
set radio wlan0 fragmentation-threshold 256-2346
set radio wlan0 rts-threshold 0-2347
set bss wlan0bssvap0 max-stations 0-200
set radio wlan0 tx-power 0-100
set radio wlan0 fixed-multicast-rate {54 | 48 |36 |24
| 18 | 12 |9 | 6 | auto}
add basic-rate wlan0 rate integer
get basic-rate
add supported-rate wlan0 rate integer
get supported-rate wlan0
get mcs-index
add mcs-index wlan0 index 0-15
remove mcs-index wlan0 index 0-15
set radio wlan0 rate-limit-enable {on | off}
set radio wlan0 rate-limit limit
set radio wlan0 rate-limit-burst limit
set radio wlan0 stbc-mode {on | off}
set radio wlan0 short-guard-interval-supported {yes |
no}

Table 9: Managed Access Point Commands

Command
get managed-ap
Managed Access Point
Table 9 show how to change
Unified Wired and Wireless Access System
Page 27