Table of Contents
Advertisement
3-6
DISA CO-to-CO
Programming Steps
1. Press the DISA CO-TO-CO flexible button (FLASH 40, Page A,
2. Enter a 0 or 1 on the dial pad to enable/disable this feature.
3. Press HOLD to save the entry. A confirmation tone is heard.
Description
The DISA CO-to-CO (or Conference) mark on the CO line governs a DISA
caller's ability to access other outside lines. CO lines must have DISA CO-
to-CO enabled to allow a DISA caller to establish an outgoing CO-to-CO
connection. This allows for specific CO line access restriction on DISA
calls. A station with Conference enabled can initiate a conference on CO
lines regardless of the CO line conference marking. By default, DISA CO-
to-CO is enabled for all CO lines.
The CO line conference flag affects a DISA caller's ability to access
outgoing CO lines as shown in the following table:
Incoming DISA CO
CO-to-CO Enabled
CO-to-CO Disabled
Button #4).
[0] = Disabled
[1] = Enabled
D ISA CO- TO- CO
EN AB LE D
Table 3-1: CO Line Conference Flag
CO-to-CO Enabled
Call Allowed
Call Denied
DISA Caller Attempts to Access
CO-to-CO Disabled
Call Denied
Call Denied
Page A Introduction
0- 1
Advertisement
Table of Contents
