Set Cos Port-Resource Irl - Enterasys Matrix DFE-Gold Series Configuration Manual

Configuring Policy Class of Service (CoS)

set cos port-resource irl

Use this command to configure a Class of Service inbound rate limiting port resource entry.
Syntax
set cos port-resource irl group-type-index irl-number {[unit {percentage | kbps |
mbps | gbps}] [rate rate] [type {drop}] [syslog {disable | enable}] [trap {disable
| enable}] [disable-port {disable | enable}]}
Parameters
group‐type‐index
irl-number
unit percentage |
kbps | mbps | gbps
rate
rate
type drop
syslog disable |
enable
trap disable | enable
disable‐port disable |
enable
Defaults
• If a rate is not specified, port defaults will be applied.
• If not specified, frames will not be dropped.
• If not specified, Syslog and port disabling will not be configured.
Mode
Switch command, Read‐Write.
Example
This example shows how to configure Class of Service port resource IRL entry 0 for port group 0.1
assigning an inbound rate limit of 512 kilobits per second This entry will trigger a Syslog and an
SNMP trap message if this rate is exceeded:
Matrix(rw)->set cos port-resource irl 0.1 0 unit kbps 512 syslog enable trap enable
8-32 Policy Classification Configuration
Specifies an inbound rate limiting port group/type index for this entry.
Valid entries are in the form of group.type. Group can be 0‐7, with 0
designating the default group, and 1‐7 reserved for user‐defined
groups. Default port type values cannot be changed, and are 0 for the
7GR4270‐12, 7G4270‐12, 7G4270‐09, and 7G4270‐10 DFE modules, and 1
for all other modules.
Specifies an inbound rate limiter ID to be associated with this entry.
Specifies the unit of measure as percentage of total bandwidth, or
kilobits, megabits, or gigabits per second.
(Optional) Data rate in units for this inbound rate limiter.
(Optional) Specifies that frames exceeding this limiter will be dropped.
(Optional) Enables or disables the generation of a Syslog message when
this limiter is exceeded.
(Optional) Enables or disables the sending of an SNMP trap message
when this limiter is exceeded.
(Optional) Enables or disables the disabling of the violating port when
this limiter is exceeded.
set cos port-resource irl