Show Radius Accounting - Enterasys N Standalone (NSA) Series Configuration Manual

14.3.2.4

show radius accounting

Use this command to display the RADIUS accounting configuration. This transmits accounting
information between a network access server and a shared accounting server.
show radius accounting [updateinterval] | [intervalminimum] | [state] | [server
{index | all}]
Syntax Description
updateinterval
intervalminimum (Optional) Displays the minimum update interval setting.
state
server index | all
Command Type
Switch command.
Command Mode
Read-Only.
Command Defaults
If no parameters are specified, all RADIUS accounting configuration information
will be displayed.
Example
This example shows how to display RADIUS accounting configuration information. In this case,
RADIUS accounting is enabled and global default settings have not been changed. One server has
been configured. The Matrix Series device allows for up to 10 RADIUS accounting servers to be
configured, with up to 2 active at any given time.
(Optional) Displays the number of seconds between each
RADIUS accounting interim update (when accumulated
accounting data is sent to the server for a session.)
This controls the frequency of RADIUS accounting
updates.
(Optional) Displays the RADIUS accounting enable state.
(Optional) Displays one or all RADIUS accounting server
configurations.
Matrix NSA Series Configuration Guide
Security Configuration Command Set
Configuring RADIUS
14-15