Set Radius - Enterasys N Standalone (NSA) Series Configuration Manual

Security Configuration Command Set
Configuring RADIUS
14.3.2.2

set radius

Use this command to enable, disable, or configure RADIUS authentication.
set radius {[enable | disable] [retries number-of-retries] [timeout timeout]
[server {index ip-address port [secret-value]} [realm {management-access |
network-access | any} {index | all}]}
NOTE: The RADIUS client can only be enabled on the switch once a RADIUS server is
online, and its IP address(es) has been configured with the same password the RADIUS
client will use.
Syntax Description
enable | disable
retries
number-of-retries
timeout timeout
server index
ip_address port
secret-value
realm
management
-access |
network-access |
any
index | all
Command Type
Switch command.
Command Mode
Read-Write.
14-12 Matrix NSA Series Configuration Guide
Enables or disables the RADIUS client.
Specifies the number of retry attempts before the RADIUS
server times out. Valid values are from 1 to 10. Default is 3.
Specifies the maximum amount of time (in seconds) to
establish contact with the RADIUS server before retry
attempts begin. Valid values are from 1 to 30. Default is 20
seconds.
Specifies the index number, IP address and the UDP
authentication port for the RADIUS server.
(Optional) Specifies an encryption key to be used for
authentication between the RADIUS client and server.
(Optional) Restricts the RADIUS server realm to
management or network access authentication, or allows it
to perform all authentications.
Applies the server realm setting to a specific server or to all
servers.