Ip Multicast Static-Group - Alcatel-Lucent OmniSwitch 6850-48 Cli Reference Manual

ip multicast static-group

Creates a static IGMP group entry on a specified port on a specified VLAN.
ip multicast static-group ip_address vlan vid port slot/port
no ip multicast static-group ip_address vlan vid port slot/port
Syntax Definitions
ip_address
vid
slot/port
Defaults
N/A
Platforms Supported
OmniSwitch 6400, 6850, 6855, 6850E, 9000E
Usage Guidelines
•
Use the no form of this command to remove an IGMP static group entry on a specified port on a speci-
fied VLAN.
•
The ip multicast static-group command allows you to create an IGMP static group entry on a speci-
fied port on a specified VLAN. This, in-turn, enables that network segment to receive IGMP traffic
addressed to the specified IP multicast group address.
•
You can also create an IGMP static group entry on a link aggregate port by entering
ip multicast static-group ip_address vlan vid port, followed by the link aggregation group number
(e.g., ip multicast static-group 11.0.0.1 vlan 2 port 7).
Examples
-> ip multicast static-group 229.10.10.10 vlan 4 port 1/1
-> no ip multicast static-group 229.10.10.10 vlan 4 port 1/1
-> ip multicast static-group 225.11.11.11 vlan 4 port 7
-> no ip multicast static-group 225.11.11.11 vlan 4 port 7
Release History
Release 6.1.1; command was introduced.
page 27-20
The IP address of the multicast group.
VLAN to include as a static IGMP group.
The slot/port number you want to configure as a static IGMP group.
IP Multicast Switching Commands
OmniSwitch CLI Reference Guide June 2012