Ip Multicast Query-Response-Interval - Alcatel-Lucent OmniSwitch 6850-48 Cli Reference Manual

ip multicast query-response-interval

Sets the IGMP query response interval on the specified VLAN or on the system if no VLAN is specified.
ip multicast [vlan vid] query-response-interval [tenths-of-seconds]
Syntax Definitions
vid
tenths-of-seconds
Defaults
parameter
tenths-of-seconds
Platforms Supported
OmniSwitch 6400, 6850, 6855, 6850E, 9000E
Usage Guidelines
•
IP Multicast Switching and Routing must be enabled to set the IGMP query response interval on the
system and/or the specified VLANs.
•
If the IGMP query response interval is already configured on the system, then the VLAN configuration
will override the system's configuration.
•
The query response interval refers to the time period to reply to an IGMP query message.
•
To restore the IGMP query response interval to its default (i.e., 100 tenths-of-seconds) value on the
system if no VLAN is specified, use ip multicast query-response-interval followed by the value 0
(e.g., ip multicast query-response-interval 0) or use only ip multicast query-response-interval (e.g.,
ip multicast query-response-interval).
•
To restore the IGMP last member query interval to its default (i.e., 100 tenths-of-seconds) value on the
specified VLAN, use ip multicast vlan vid query-response-interval followed by the value 0 (e.g., ip
multicast vlan 2 query-response-interval 0) or use only ip multicast vlan vid query-response-interval
(e.g., ip multicast vlan 2 query-response-interval).
Examples
-> ip multicast query-response-interval 200
-> ip multicast query-response-interval 0
-> ip multicast query-response-interval
-> ip multicast vlan 2 query-response-interval 300
-> ip multicast vlan 2 query-response-interval 0
-> ip multicast vlan 2 query-response-interval
page 27-26
VLAN on which to apply the configuration.
IGMP query response interval in tenths of seconds. Valid range is 1 to
65535.
default
100
IP Multicast Switching Commands
OmniSwitch CLI Reference Guide June 2012