Policy Condition Dscp - Alcatel-Lucent OmniSwitch 6250 Cli Reference Manual

QoS Policy Commands

policy condition dscp

Configures the Differentiated Services Code Point (DSCP) for a policy condition. The DSCP value
defines the six most significant bits of the DS byte in the IP header.
policy condition condition_name dscp {dscp_value[-value]}
policy condition condition_name no dscp
Syntax Definitions
condition_name
{dscp_value[-value]}
Defaults
N/A
Platforms Supported
OmniSwitch 6250
Usage Guidelines
•
Use the no form of this command to remove a DSCP value from a condition; however, at least one
classification parameter must be associated with a condition.
•
If a DSCP value is specified, a ToS value may not be specified.
Examples
-> policy condition cond4 dscp 10
-> policy condition cond5 dscp 20-30
Release History
Release 6.6.1; command was introduced.
Related Commands
policy condition
qos apply
show policy condition
MIB Objects
alaQoSConditionTable
alaQoSConditionName
alaQoSConditionDscp
OmniSwitch CLI Reference Guide
The name of the condition. May be an existing condition name or a new
condition.
The DiffServ Code Point value, in the range 0–63. Use a hyphen to
specify a range of DSCP values for the condition (for example, 10-20).
Creates a policy condition.
Applies configured QoS and policy settings to the current configuration.
Shows information about policy conditions configured on the switch.
November 2009 page 39-85