At-Is230-10Gp Reset Button - Allied Telesis AT-IS230-10GP Installation Manual

Chapter 1: Overview

AT-IS230-10GP Reset Button

36
The Reset button is only available on the AT-IS230-10GP switch and it
resets the switch. You might reset the switch if it is experiencing a
problem. The reset button is recessed in the chassis. To press it, use a
straightened paper clip or similar object.
The switch behaves as follows:
Hold it for 5 sec: The switch software will reboot and return the

configuration settings to factory defaults.
Hold it for 2 sec: The switch software will reboot and keep the

existing configuration settings that have been previously saved.
Caution
The switch does not forward network traffic for approximately one
minute while it initializes its management operating system. Some
network traffic may be lost.
Note
Unsaved changes to the configuration settings of the switch are
discarded when you reset the device.