Reset Button; Ground Screw - Allied Telesis IE340 Series Installation Manual

IE340 Series Installation Guide

Reset Button

Ground Screw

36
The Reset button resets the switch. You might reset the switch if it is
experiencing a problem. The reset button is recessed in the chassis. To
press it, use a straightened paper-clip or similar object.
Caution
The switch does not forward network traffic during the reboot
process. Some network traffic may be lost.  E113
Note
It takes approximately one minute during the reboot process.
Note
Unsaved changes to the configuration settings of the switch are
discarded when you reset the device.
The ground screw is used to connect the chassis to the earth ground at
the installation site. The instructions for connecting the post are provided
later in this guide.
Warning
The switch must be connected to an earth ground. Do not operate
the device without an earth ground. E129
