Router Ospf - Allied Telesis IE340 Series Command Reference Manual

OSPF C
OMMANDS

ROUTER OSPF

router ospf
Overview Use this command to enter Router Configuration mode to configure an OSPF
routing process. You must specify the process ID with this command for multiple
OSPF routing processes on the device.
Use the no variant of this command to terminate an OSPF routing process.
Use the no parameter with the process-id parameter, to terminate and delete a
specific OSPF routing process. If no process-id is specified on the no variant of this
command, then all OSPF routing processes are terminated, and all OSPF
configuration is removed.
router ospf [<process-id>]
Syntax
no router ospf [<process-id>]
Default No routing process is defined by default.
Mode Global Configuration
Usage notes The process ID of OSPF is an optional parameter for the no variant of this command
only. When removing all instances of OSPF, you do not need to specify each
Process ID, but when removing particular instances of OSPF you must specify each
Process ID to be removed.
Example To enter Router Configuration mode to configure an existing OSPF routing process
100, use the commands:
awplus#
awplus(config)#
awplus(config-router)#
C613-50631-01 Rev A
Parameter
<process-id>
configure terminal
router ospf 100
Command Reference for IE340 Series
AlliedWare Plus™ Operating System - Version 5.5.3-0.x
Description
A positive number from 1 to 65535, that is used to define a
routing process.
1171