Honda Accord 2008 Manual page 2331

Hide thumbs Also See for Accord 2008:

Table of Contents

07/11/02 09:40:00 61TA0000_220_0301

Wipers/Washers

Wiper/Washer Switch Test/Replacement

1. Remove the steering column covers (see page

2. Disconnect the dashboard wire harness 8P

connector (A) from the wiper/washer switch (B).

3. Remove the two screws, then slide out the wiper/

washer switch.

4. Inspect the connector terminals to be sure they are

all making good contact.

• If the terminals are bent, loose or corroded,

repair them as necessary, and recheck the

• If the terminals look OK, go to step 5.

5. Check for continuity between the terminals in each

switch position according to the table.

Intermittent dwell

timer turned

6. If the continuity is not as specified, replace the

7. Install the switch in the reverse order of removal.

ＴＡ０８Ａ００Ｊ５４３０００６５８０１ＦＨＡＴ００

Chapters

Table of Contents