Honda Accord 2008 Manual page 2300

07/11/02 09:38:44 61TA0000_220_0270
DTC B1145: Passenger's Power Window
Position Information Error
NOTE: If you are troubleshooting multiple DTCs, be
sure to follow the instructions in B-CAN System
Diagnosis Test Mode A (see page 22-120).
1. Clear the DTCs with the HDS.
2. Turn the ignition switch to LOCK (0) and then back
to ON (II).
3. Open and close the front passenger's power
window by using the front passenger's power
window switch.
4. Check for DTCs with the HDS.
Are DT Cs B1130 and B1131 also indicated?
−
YES Troubleshoot the indicated DTC(s) first.
NO − Go to step 5.
5. Reset the power window control unit (see page
22-253).
6. Clear the DTCs with the HDS.
7. Turn the ignition switch to LOCK (0) and then back
to ON (II).
8. Open and close the front passenger's power
window by using the front passenger's power
window switch.
9. Check for DTCs with the HDS.
Is DT C B1145 indicated?
YES − Go to the passenger's power window switch
input test, and do all the power and ground input
tests (see page 22-273). If all the tests prove OK,
replace the passenger's power window switch.
−
NO The system is OK at this time. Check the
connectors and terminals for poor or loose
connections.
ＴＡ０８Ａ００Ｋ７６４０００Ｙ１１４５ＦＡＡＴ００
DTC U0155: Door Multiplex Control Unit Lost
Communication with Gauge Control Module
NOTE: If you are troubleshooting multiple DTCs, be
sure to follow the instructions in B-CAN System
Diagnosis Test Mode A (see page 22-120).
1. Clear the DTCs with the HDS.
2. Turn the ignition switch to LOCK (0) and then back
to ON (II).
3. Wait for 6 seconds or more.
4. Check for DTCs with the HDS.
Is DT C U0155 indicated?
YES − Go to the gauge control module input test,
and do all power, ground and communication input
tests (see page 22-328). If the tests prove OK,
replace the gauge control module.
NO − Intermittent failure, the system is OK at this
time. Check for loose or poor connections at the
gauge control module and the related units.
ＴＡ０８Ａ００Ｋ７６４０００Ｕ０１５５ＦＡＡＴ００
22-267 22-267