Connection Of Development Pc And Controller With Ethernet - Epson RC700 Manual

Setup & Operation 7. LAN (Ethernet Communication) Port
7.4 Connection of Development PC and Controller with
Ethernet
Connection between the development PC and the Controller is shown below.
(1) Connect the development PC and the Controller using the Ethernet cable.
(2) Turn on the Controller.
(3) Start EPSON RC+ 7.0.
(4) Display the [PC to Controller Communication] dialog from [Setup] in EPSON RC+
(5) Click the <Add> button.
(6) Connection "No.2" is added. Set the following and click the <Apply> button.
(7) [Name] and [IP Address] specified in procedure (6) is displayed.
48
7.0 menu.
Name : Valid value to identify the controller to connect
IP Address : IP address for Controller to connect
RC700 / RC700-A Rev.23