Expansion I/O Board; Board Configuration (Expansion I/O Board); Confirmation With Epson Rc+ 7.0 (Expansion I/O Board) - Epson RC700 Manual

Robot controller
Hide thumbs Also See for RC700:
Table of Contents

Advertisement

Setup & Operation 14. Option Slots

14.2 Expansion I/O Board

14.2.1 Expansion I/O Board
Each additional expansion I/O board provides 24 inputs and 16 outputs.
You can install up to four expansion I/O boards in the controller.
The input and output bit numbers are assigned as follows. (Bit number is assigned from
CN1.)

14.2.2 Board Configuration (Expansion I/O Board)

Board Appearance
CN3
DSW1

14.2.3 Confirmation with EPSON RC+ 7.0 (Expansion I/O Board)

When an expansion I/O board is mounted to the option unit, the Controller software
automatically identifies the expansion I/O board. Therefore, no software configuration is
needed.
Correct identification can be confirmed from EPSON RC+ 7.0.
80
Input Bit #
0 to 23
64 to 87
96 to 119
128 to 151
160 to 183
Switch and Jumper Configuration
Setup the DSW1 and DSW2. CN3 is all open.
st
1
board
SW1
SW2
SW3
SW4
SW5
SW6
DSW2
SW7
SW8
SW1
SW2
SW3
SW4
Output Bit #
0 to 15
64 to 79
The 1
96 to 111
The 2
128 to 143
The 3rd Expansion I/O board
160 to 175
The 4th Expansion I/O board
rd
nd
3
board
2
board
SW1
SW2
SW3
SW4
SW5
SW6
SW7
SW8
SW1
SW2
SW3
SW4
Applicable Hardware
STANDARD I/O
st
Expansion I/O board
nd
Expansion I/O board
th
4
board
SW8
SW8
SW7
SW7
SW6
SW6
SW5
SW5
SW4
SW4
SW3
SW3
SW2
SW2
SW1
SW1
SW4
SW4
SW3
SW3
SW2
SW2
SW1
SW1
RC700 / RC700-A Rev.23

Hide quick links:

Advertisement

Table of Contents
loading

This manual is also suitable for:

Rc700-a

Table of Contents