Download  Print this page

Epson RC700 Manual Page 37

Robot controller.
Hide thumbs
Also See for RC700
Manual - 274 pages
Manual - 66 pages

Advertisement

Included items of the wall mounting option
■ Before installing the controller with this option, always make sure that the main
power of the Controller is turned OFF and that the power plug is disconnected.
Performing any installation procedure while the main power is ON or the high
voltage charged area is not discharged completely is extremely hazardous and
may result in electric shock and/or cause serious safety problems.
■ When opening the front side, make sure to disconnect the power plug.
WARNING
Touching the power supply terminal block inside the Controller while the power
supply is ON is extremely hazardous and may result in electric shock and/or
cause serious safety problems.
- Be careful not to damage the cables.
NOTE
- Be careful not to drop any screws into the Controller.
(1) Remove the Top Cover Mounting screws of the
(2) Remove the Top Cover.
(3) Remove the screws fixing the seven segment
(4) Remove the LED/7 segment board from the
NOTE
RC700 / RC700-A Rev.23
WALL FIXING BRACKET
LED DISPLAY FIXING PLATE
LED DISPLAY PLATE
Screw (M3 × 6 mm)
Screw (M4 × 8 mm)
controller
(Mounting screw×6)
display.
(Controller front side: Mounting screw×2)
controller.
For RC700-A:
The LED/7 segment board has the ferrite code
(Reference: Maintenance
7.8.2 DMB-LED Board (RC700-A))
If the LED DISPLAY PLATE is installed with
"wall mounting with the front side up" described
in the step (7) below, the cable which passes the
ferrite core will be an opposite direction.
Remove the latch of the ferrite core and change
the cable direction, and then install the ferrite
core again.
Safety 3. Installation
2 brackets
1 plate
1 plate
4 screws
4 screws
25

Advertisement

Table of Contents

   Also See for Epson RC700

   Related Manuals for Epson RC700

This manual is also suitable for:

Rc700-a

Comments to this Manuals

Symbols: 0
Latest comments: