Epson RC700 Manual page 293

Robot controller
Hide thumbs Also See for RC700:
Table of Contents

Advertisement

No.
Message
The specified vision sequence
7523
already exists.
The specified vision object already
7524
exists.
7525
Cannot load vision project.
7526
Cannot save vision project.
7527
Vision processor. Critical error.
7528
Image file not found.
7529
Camera does not exist.
7530
Acquisition failed.
7531
No objects to train.
7532
Cannot load image file.
Camera is not supported by
7533
RC+7.0.
Camera firmware does not support
7534
new functions of RC+7.0.
7535
Invalid data from network camera.
Network camera export status
7536
failed
Invalid ImageSize value. The
7537
specified value is not supported by
the camera.
Invalid ZoomFactor. The specified
7538
value requires data outside of the
image area.
The camera does not support Code
7539
Reader.
7540
The camera does not support OCR.
7541
Insufficient data for teaching model.
Model window cannot be outside of
7542
image.
Calibration points have not been
7543
taught.
7544
Calibration must be fixed upward.
7545
Point was not defined.
RobotPlacePos has not been
7546
calibrated.
Camera IP address is out of current
7547
subnet.
7548
Camera was not detected.
Invalid Radius. Radius must be
7549
>= RadiusInner and <=
RadiusOuter.
7550
OCR character does not exist.
7551
OCR option is not active.
RC700 / RC700-A Rev.23
Remedy
Change the sequence name.
Delete the existing sequence in
advance.
Change the object name.
Delete the existing sequence in
advance.
The project folder may be corrupt.
Restore backup data.
The project folder may be
write-protect.
Check the access permission for the
project folder.
Initialize the camera.
Rebuild the project.
Check the image file.
Check the camera connection.
Check the camera connection.
Teach the model.
Check the image file.
SC300/SC1200 is not supported by
RC+7.0.
Use CV1/CV2.
Update the camera firmware.
Initialize the camera.
Initialize the camera.
ImageSize exceeding the camera
resolution cannot be specified.
Correct the property value.
Settable values are from 0.1 to 10.0.
Correct the property value.
Update the camera firmware.
Update the camera firmware.
Black or white image cannot be
registered as a model.
Correct the position of the model
window.
Teach the calibration point.
Sequence with the calibration data of
the upward fixed camera is only
settable.
Teach the calibration point.
Click CalRobotPlacePos and
calibrate RobotPlacePos.
Correct the camera IP address.
Check the wiring of the camera.
Correct the property value.
Register the OCR character.
Enable the option.
Maintenance 9. Troubleshooting
Note 1
Note 2
281

Hide quick links:

Advertisement

Table of Contents
loading

This manual is also suitable for:

Rc700-a

Table of Contents