Epson RC700 Manual page 188

Maintenance 9. Troubleshooting
No. Message
Operation Failure.
1001
Command parameter is invalid.
Requested data cannot be
1002 accessed. The data is not set up
or the range is invalid.
1003 The password is invalid
Cannot execute with unsupported
1004
version.
Cannot execute with invalid serial
1005
number.
Cannot execute with invalid Robot
1006
model.
Cannot execute with invalid
1007
Controller.
Remote setup error.
1010 Cannot assign R-IO input number
to remote input.
Remote setup error.
Cannot assign a bit number which
1011 does not exist to a remote I/O
signal.
Check the fieldbus slave size.
Remote setup error.
Cannot assign a bit number which
1012 does not exist to a remote I/O
signal.
Check the fieldbus master size.
Fieldbus slave failure.
Cannot change the size because it
1013
currently includes a remote I/O
signal.
Fieldbus master failure. Cannot
change the size because it
1014
currently includes a remote I/O
signal.
Remote setup error. Cannot assign
1015 Hand-IO input/output number to
remote input.
1020 Cannot execute in recovery mode.
Cannot execute due to controller
1021
initialization failure.
Cannot execute without the project
1022
being open.
Cannot execute while the project is
1023
open.
1024 Cannot activate from remote.
Execution in Teach mode is
1025
prohibited.
Cannot execute in Teach mode
1026
except from TP.
1027 Cannot execute in Auto mode.
Cannot execute in Auto mode
1028
except from the main console.
1029 Cannot execute from OP.
176
Remedy
-
Check whether the target I/O,
variables, and tasks exist.
Enter the correct password.
Use the correct version file.
Use the backup data for the same
controller to restore the controller
configuration.
Use the backup data for the same
controller to restore the controller
configuration.
Use the supported installer.
Specify the input number excluding
the R-IO input number.
Check the fieldbus slave size.
Check the fieldbus master size.
-
-
-
Boot the controller as normal.
Restore the controller configuration.
Open a project.
Rebuild the project.
Enable the remote input.
Change to the AUTO mode.
Change to the AUTO mode.
Change to the Program mode.
Change to the Program mode.
Enable the OP input.
Note 1 Note 2
RC700 / RC700-A Rev.23