Epson RC700 Manual page 197

No. Message
1863 The parameter is invalid.
Initialization failure.
1864
Virtual controller does not exist.
Initialization failure.
1865
Failed to start virtual controller.
Cannot execute because it is not
1867
dry run mode.
Initialization failure.
1868
Directory cannot be found.
Connection failure.
1872 Files for simulator that used real
controller cannot be found.
Connection failure.
1873 Files for simulator that used virtual
controller cannot be found.
1874 Virtual Controller cannot be added.
Simulator Object failure.
1875 Cannot load data for the simulator
object.
Simulator Object failure.
1876 Cannot read data for the simulator
object.
Simulator Object failure.
1877 Cannot remove data from the
simulator object.
Simulator Object failure.
1878 Cannot update data for the
simulator object.
Other virtual controllers are
1879
starting.
Cannot execute during controller
1880
reset.
Unsupported.
1901 Unsupported command was
attempted.
Unsupported.
1902 Unsupported parameter was
specified.
1903 System error.
System error.
1910
Failed to write the reboot file.
RC700 / RC700-A Rev.23
Remedy
-
Installation of the EPSON RC+ 7.0
failed. Reinstall the software.
1. Retry after a while.
2. Reboot the PC.
Dry run mode is invalid.
Enable the dry run.
Installation of the EPSON RC+ 7.0
failed. Reinstall the software.
-
-
Installation of the EPSON RC+ 7.0
failed. Reinstall the software.
-
-
-
-
Other virtual controllers may be used
in the EPSON RC+ 5.0.
Or, the virtual controller may be
already used in another EPSON
RC+7.0.
-
Update the firmware.
-
-
-
Maintenance 9. Troubleshooting
Note 1 Note 2
185