Epson RC700 Manual page 286

Maintenance 9. Troubleshooting
No. Message
Specified point label is beyond the
7030 maximum length. Specify a valid
point label.
Description for the specified point
7031 is beyond the maximum length.
Specify a valid description.
Point file is corrupted. Check sum
7032
error.
Specified point file cannot be
7033 found. Specify a valid point file
name.
7034 Cannot save the point file.
7035 Cannot save the point file.
7036 Cannot save the point file.
7037 Cannot save the point file.
7038 Cannot save the point file.
7039 Cannot save the point file.
The point label is not correct.
7040
Specify a valid point label.
The point label is not correct.
7041
Specify a valid point label.
7042 The pallet cannot be defined.
7043 Invalid point file version.
The point file format version is
7044
unsupported.
The specified work queue number
7045
is invalid.
274
Remedy
Change the point label.
Change the comment.
Create the point file again.
Check the name of the specified point
file.
Failed to save the point file (create a
temporary file).
Reboot the controller.
Initialize the controller firmware.
Replace the controller.
Failed to save the point file (file
open).
Reboot the controller.
Initialize the controller firmware.
Replace the controller.
Failed to save the point file (renew
the file header).
Reboot the controller.
Initialize the controller firmware.
Replace the controller.
Failed to save the point file (create
the file name).
Reboot the controller.
Initialize the controller firmware.
Replace the controller.
Failed to save the point file (copy the
file).
Reboot the controller.
Initialize the controller firmware.
Replace the controller.
Failed to save the point file (change
the file name).
Reboot the controller.
Initialize the controller firmware.
Replace the controller.
The initial character of the point label
name is improper. Correct the label
name.
Inadequate character is used.
Correct the label name.
Undefined flag for pallet data is
mixed.
Check the point data.
Correct the point data.
The point file version is different.
Re-create the point file.
The point file is not supported.
Re-create the point file.
Check the specified work queue
number.
Note 1 Note 2
RC700 / RC700-A Rev.23