Epson RC700 Manual page 206

Maintenance 9. Troubleshooting
No. Message
Variable overflow. Specified
2243 variable was beyond the maximum
allowed value.
Variable underflow. Specified
2244 variable was below the minimum
allowed value.
Cannot execute this command with
2245
a floating point number.
Cannot calculate the specified
2246
value using the Tan function.
Specified array subscript is less
2247
than ' 0 '.
Array failure. Redim can only be
2248
executed for an array variable.
Array failure. Cannot specify
2249 Preserve for other than a single
dimension array.
Array failure. Failed to calculate
2250
the size of the variable area.
Cannot allocate enough memory for
2251
Redim statement.
Cannot allocate enough memory for
2252
ByRef.
Cannot compare characters with
2253
values.
Specified data is beyond the array
2254 bounds. Cannot refer or update
beyond the array bounds.
Variable overflow or underflow.
2255 Specified variable is out of value
range.
Specified array subscript is beyond
2256
the maximum allowed range.
Cannot specify Int64 variable or
2257
UInt64 variable.
Task number is out of the available
2260
range.
Specified task number does not
2261
exist.
Robot number is out of the
2262
available range.
Output number is out of the
available range. The Port No. or
2263
the Device No. is out of the
available range.
194
Remedy
Check the variable type and
calculation result. Review the
program.
Check the variable type and
calculation result. Review the
program.
This command cannot be executed
for Real or Double type. Review the
program.
Check the specified value. Review
the program.
Check the specified value. Review
the program.
You attempted to Redim the variable
that is not array. Rebuild the
project.
Other than a single dimension array
was specified as Preserve for Redim.
Rebuild the project.
Rebuild the project.
Reduce the number of subscripts to
be specified for Redim. Perform
Redim modestly.
Reduce the number of array's
subscripts to be seen by ByRef.
Check whether the string type and
the numeric data type are not
compared. Review the program.
Check the number of array's
subscripts and data. Review the
program.
The value that exceeds the range of
Double type is specified. Review
the program.
Reduce the number of subscripts to
be specified. For available
subscripts, see the online help.
Int64 variable or UInt64 variable
cannot be specified. Correct the
program.
For available task number, see the
online help. Review the program.
Review the program.
The available Robot number is 1.
Review the program.
For available output number, see the
online help. Review the program.
Note 1 Note 2
The specified
value
The specified
value
The number
The number
of data to be
of array
referred or
subscripts
updated
The specified
task number
The specified
task number
The specified
robot number
The specified
output
number
RC700 / RC700-A Rev.23