Download  Print this page

Safety Precautions - Epson RC700 Manual

Robot controller.
Hide thumbs
Also See for RC700
Manual - 274 pages
Manual - 66 pages

Advertisement

Safety 3. Safety Precautions

3. Safety Precautions

Only trained personnel should design and install the robot system.
Trained personnel are defined as those who have taken robot system training class held by
the manufacturer, dealer, or local representative company, or those who understand the
manuals thoroughly and have the same knowledge and skill level as those who have
completed the training courses.
The following items are safety precautions for qualified design or installation
personnel:
 Personnel who design and/or construct the robot system with this product must
read the Safety chapter in User's Guide to understand the safety requirements
before designing and/or constructing the robot system.
constructing the robot system without understanding the safety requirements is
extremely hazardous, may result in serious bodily injury and/or severe equipment
damage to the robot system, and may cause serious safety problems.
 The Manipulator and the Controller must be used within the environmental
conditions described in their respective manuals.
designed and manufactured strictly for use in a normal indoor environment.
Using the product in an environment that exceeds the specified environmental
conditions may not only shorten the life cycle of the product but may also cause
serious safety problems.
 The robot system must be used within the installation requirements described in
the manuals. Using the robot system outside of the installation requirements
WARNING
may not only shorten the life cycle of the product but also cause serious safety
problems.
 The interlock of the Safety Door must be functioning when the robot system is
operated. Do not operate the system under the condition that the switch cannot
be turned ON/OFF. (I.E. the condition where the switch is disabled)
(Example: Tape is put around the switch to hold it closed.) Operating the robot
system when the switch is not functioning properly is extremely hazardous and
may cause serious safety problems as the Safety Door input cannot fulfill its
intended function.
 Connect input signal wires for Emergency Stop and Safety Door to the
EMERGENCY connector so that the Emergency Stop switch in the Teach
Pendant connected to the TP port always functions.
application diagram in Setup & Operation 9.4 Circuit Diagrams.)
4
Designing and/or
This product has been
(Refer to the typical
RC700 / RC700-A Rev.23

Advertisement

Table of Contents

   Also See for Epson RC700

   Related Manuals for Epson RC700

This manual is also suitable for:

Rc700-a

Comments to this Manuals

Symbols: 0
Latest comments: