Epson RC700 Manual page 237

No. Message
The specified file name includes
3313
character(s) that cannot be used.
3314 Cannot open the file.
' ** ' is already used for a function
3315
name.
' ** ' is already used for a global
3316
preserve variable name.
' ** ' is already used for a global
3317
variable name.
' ** ' is already used for a module
3318
variable name.
Dimension of the array variable
3319
does not match the declaration.
Return value type of the function
3320
does not match the declaration.
' ** ' is already used with function
3321
name.
' ** ' is already used with Global
3322
Preserve name.
' ** ' is already used with Global
3323
name.
' ** 'is already used with Module
3324
name.
' ** ' is already used with Local
3325
name.
The number of parameters does
3326
not match the declaration.
ByRef was not specified in
3327 Function declaration for parameter
**.
ByRef was not specified for
3328
parameter **.
3329 Parameter ** type mismatch.
Linked OBJ file does not match the
3330
compiled Vision Project.
OBJ file size is beyond the
3331
available size after linking.
3332 Variable '**' is redefined.
Linked OBJ file does not match the
3333
compiled GUI Builder Project.
The number of variables which is
3334 using Wait command is beyond the
maximum allowed.
Call cannot be used in parallel
3335
processing.
RC700 / RC700-A Rev.23
Remedy
-
The file is used for other application.
Quit the other application.
Correct the identifier ' ** ' or the
function name. Rebuild the project.
Correct the identifier ' ** ' or the global
preserve variable name. Rebuild
the project.
Correct the identifier ' ** ' or the global
variable name. Rebuild the project.
Correct the identifier ' ** ' or the
module variable name. Rebuild the
project.
Correct the dimension of the array
and rebuild the project.
Correct the return value type of the
function and rebuild the project.
Correct the identifier ' ** ' or the
function name. Rebuild the project.
Correct the identifier ' ** ' or the global
preserve variable name. Rebuild
the project.
Correct the identifier ' ** ' or the global
variable name. Rebuild the project.
Correct the identifier ' ** ' or the
module variable name. Rebuild
the project.
Correct the identifier ' ** ' or the local
variable name. Rebuild the project.
Check the number of parameters in
the function, correct the program, and
then rebuild the project.
-
-
-
Rebuild the project.
The OBJ file size exceeds the limit
value (8MB). Reduce the program.
Variable ' ** ' is overloaded. Delete
unnecessary variable definition and
rebuild the project.
Rebuild the project.
The number of variables which is
using Wait command is exceeding
the maximum allowed (64). Delete
the variables and rebuild the project.
Call cannot be used in parallel
processing. Correct the program
and rebuild the project.
Maintenance 9. Troubleshooting
Note 1 Note 2
225