Alarm Notifying Method; How To Cancel The Alarm - Epson RC700 Manual

Robot controller
Hide thumbs Also See for RC700:
Table of Contents

Advertisement

6.2.4 Alarm Notifying Method

The controller status becomes warning and displays warning message if any parts required
to perform replacement or grease up.
For details, refer to the following manual.
Maintenance 9.1 Error Code Table
The alarm notifying method can be configured by the output bit of the Remote I/O.
The Remote I/O can be configured in the EPSON RC+ 7.0- [Setup] - [System
Configuration] - [Controller] - [Remote Control].
For details, refer to EPSON RC+ 7.0 User's Guide 12.1 Remote I/O.
NOTE
The controller enters the warning state if an alarm occurs.

6.2.5 How to Cancel the Alarm

An alarm occurs when the consumption rate of the parts reaches 100%.
NOTE
The alarm cannot be canceled by executing the Reset command or restarting the controller.
The alarm can be canceled by following methods.
EPSON RC+ 7.0 [Maintenance] dialog box.
HealthCtrlReset Command
HealthRBReset Command
Refer to Maintenance 6.2.3 How to Edit the Maintenance Information to change the alarm
information in the same steps.
RC700 / RC700-A Rev.23
Maintenance 6. Alarm
147

Hide quick links:

Advertisement

Table of Contents
loading

This manual is also suitable for:

Rc700-a

Table of Contents