Changing Controller Ip Address - Epson RC700 Manual

Robot controller
Hide thumbs Also See for RC700:
Table of Contents

Advertisement

Use an address from the following Internet private environment such as P2P or line.
Make sure that the address is not redundantly assigned inside the closed network.
172.16.0.1
192.168.0.1
The following is the configuration of the controller at delivery.
IP Address : 192.168.0.1
IP Mask
IP Gateway : 0.0.0.0
Set separate IP addresses in the same subnet for PC and the controller.
PC
Controller

7.3 Changing Controller IP Address

This section describes the procedure to change the Controller IP address.
(1) Connect between the development PC and the Controller using the USB cable by
(2) Select the EPSON RC+ 7.0 menu-[Setup]-[Controller] to display the following dialog.
(3) Select [Controller]-[Configuration].
(4) Enter the proper IP address and subnet mask and click the <Apply> button.
(5) Click the <Close> button. The Controller reboots automatically.
RC700 / RC700-A Rev.23
Setup & Operation 7. LAN (Ethernet Communication) Port
Private Address List
10.0.0.1
to
10.255.255.254
to
172.31.255.254
to
192.168.255.254
: 255.255.255.0
: 192.168.0.10
: 192.168.0.1
referring to Setup & Operation
IP address configuration is completed and the Controller reboot dialog disappears.
5. Development PC Connection USB Port
.
47

Hide quick links:

Advertisement

Table of Contents
loading

This manual is also suitable for:

Rc700-a

Table of Contents