How To Edit The Maintenance Information - Epson RC700 Manual

Robot controller
Hide thumbs Also See for RC700:
Table of Contents

Advertisement

Maintenance 6. Alarm

6.2.3 How to Edit the Maintenance Information

The configured maintenance information can be edited in the EPSON RC+ 7.0 Ver.7.2.x
or later.
(1) Select the EPSON RC+ 7.0 menu-[Tools]-[Maintenance] to display the [Controller
(2) To edit the maintenance information, display the [Maintenance] dialog box.
(3) Select "General" or specify the axis from the tree to display information of the target
(4) Select the alarm to be changed and click the <Change> button.
(5) Display the [Change Alarm] dialog box and enter any of the followings.
(6) Click the <OK> button and change the specified alarm information.
NOTE
The offset can be set for the consumption rate of already installed parts.
Follow the steps below to calculate a rough offset setting value.
1. Measure the usable months for the past operation by HealthRBAnalysis.
2. Confirm the past Motor ON time in the controller status viewer.
3. Calculate a rough offset value with the following formula.
For details, refer to the following manual.
EPSON RC+ 7.0 SPEL+ Language Reference
146
Tools] dialog box.
parts.
Purchase or replacement date of the battery
Date of grease up
Purchase or replacement date of the timing belt
Purchase or replacement date of the motor
Purchase or replacement date of the reduction gear unit
Purchase or replacement date of the ball screw spline unit
Offset=100×
24×30.4375× Usable months
Motor On time
RC700 / RC700-A Rev.23

Hide quick links:

Advertisement

Table of Contents
loading

This manual is also suitable for:

Rc700-a

Table of Contents