Epson RC700 Manual page 233

No. Message
Condition expression does not
3257
evaluate to Boolean value.
RS232C port number was not
3258
specified.
Network communication port
3259
number was not specified.
3260 Language ID was not specified.
3261 Expected '.'.
Vision Sequence Name was not
3262
specified.
Vision Sequence Name or
3263 Calibration Name was not
specified.
Vision Property Name or Result
3264
Name was not specified.
Vision Property Name, Result
3265 Name or Object Name was not
specified.
Vision Calibration Property Name
3266
was not specified.
3267 Task type was not specified.
3268 Form name was not specified.
Property Name or Control Name
3269
was not specified.
3270 Property Name was not specified.
RC700 / RC700-A Rev.23
Remedy
Condition expression in If, ElseIf, Do,
and Loop statement must return a
Boolean value. Correct the
condition expression to return a
Boolean value.
RS-232C port number is not specified
in ChkCom function. Refer to
SPEL+ Language Reference
"ChkCom Function" and specify a
proper port number.
Network communication port number
is not specified in ChkNet function.
Refer to SPEL+ Language Reference
"ChkNet Function" and specify a
proper port number.
Language ID is not specified in
ErrMsg$ function. Refer to SPEL+
Language Reference
"ErrMsg$ Function" and specify a
proper language ID.
Add '.'.
Vision sequence name is not
specified in Vision Guide commands
such as VSet, VGet, and VRun. Add
a sequence name.
Vision sequence name or calibration
name is not specified in VSet and
VGet statements. Add a sequence
name or calibration name.
Vision property name or result name
is not specified in VSet and VGet
statements. Add a property name or
result name.
Either of Vision property name, result
name, or object name is not specified
in VSet and VGet statements. Add
either of a property name, result
name, or object name.
Vision calibration property name is
not specified in VSet and VGet
statements. Add a property name.
Task type is not specified in Xqt
statement. Refer to SPEL+
Language Reference "Xqt Statement"
and specify a proper task type.
Form name is not specified in GSet,
GGet, GShow, GShowDialog, and
GClose statements. Specify a form
name.
Property name or control name is not
specified in GSet and GGet
statements. Specify a property
name or control name.
Property name is not specified in
GSet and GGet statements. Specify
a property name.
Maintenance 9. Troubleshooting
Note 1 Note 2
221