Epson RC700 Manual page 238

Maintenance 9. Troubleshooting
No. Message
3336 Variable was redefined.
Invalid object index was specified.
3351
Force Guide Sequence Name was
3352
not specified.
Force Guide Property Name or
3353
Result Name was not specified.
Force Guide Property Name,
3354 Result Name or Object Name was
not specified.
Force Guide project file has
3355
unsupported file format.
Linked OBJ file does not match the
3356
compiled Force Guide Project.
3400 Dialog ID was not specified.
Main function name was not
3401
specified.
Vision object name was not
3402
specified.
Recover mode ID was not
3403
specified.
3404 Trap condition was not specified.
3405 DialogResult was not specified.
3406 MsgBox_Type was not specified.
Byte type array variable was not
3407
specified.
Single array variable was not
3408
specified.
226
Remedy
Correct the data type of the variable
and rebuild the project.
Dialog ID is not specified in
RunDialog statement. Refer to
SPEL+ Language Reference
"RunDialog Statement" and specify a
dialog ID.
Name of the main function to execute
is not specified in StartMain
statement. Specify a main function
name (main to main63).
Vision object name is not specified in
VLoadModel, VSaveModel,
VShowModel, VTeach, and VTrain
statements. Specify an object
name.
Recover mode is not specified in
Recover statement or Recover
function. Refer to SPEL+ Language
Reference "Recover Statement" and
specify a proper mode.
Trap number or trap event is not
specified in Trap statement. Refer
to SPEL+ Language Reference "Trap
Statement" and specify a proper trap
number or event.
DialogResult property setting value is
not specified in GSet statement.
Refer to GUI Builder 7.0
"DialogResult Property" and specify a
proper setting value.
Display type is not specified in
MsgBox statement. Refer to SPEL+
Language Reference "MsgBox
Statement" and specify a proper
setting value.
Byte type array variable is not
specified for send or receive data in
FbusIO_SendMsg statement.
Send/receive data must be specified
by Byte type array.
The number of dimensions is not
proper in the command where single
array variable is only available.
Correct the number of dimensions.
Note 1 Note 2
RC700 / RC700-A Rev.23