Download  Print this page

Wall Mounting Option - Epson RC700 Manual

Robot controller.
Hide thumbs
Also See for RC700
Manual - 274 pages
Manual - 66 pages


Safety 3. Installation
- Ensure the draft around the in/out and prevent the other equipment, walls and install the
Controller by keeping the distance as follows for maintenance.
the Controller Fan
50 mm
200 mm
Excluding the installation side such as base table
- Hot air with higher temperature than the ambient temperature (about 10 °C) comes out
from the Controller. Make sure that heat sensitive devices are not placed near the
- Arrange the cables in front of the Controller so that you can pull the Controller forward.

3.2.3 Wall Mounting Option

The control unit has a wall mounting option. This section describes the installation
Wall mounting with the front side down
Controller outer dimensions when using the wall mounting option
Dimensions of the mounting holes for the wall
Air Flow of
200 mm
100 mm
50 mm
Wall mounting with the front side up
(Figure/Picture: RC700)
(Unit: mm)
RC700 / RC700-A Rev.23


Table of Contents

   Also See for Epson RC700

   Related Manuals for Epson RC700

This manual is also suitable for:


Comments to this Manuals

Symbols: 0
Latest comments: