Checking Latch Release Switch Operation - Epson RC700 Manual

Robot controller
Hide thumbs Also See for RC700:
Table of Contents

Advertisement

Setup & Operation 9. EMERGENCY

9.1.3 Checking Latch Release Switch Operation

After connecting the safety door switch and latch release switch to the EMERGENCY
connector, be sure to check the switch operation for safety by following the procedures
described below before operating the Manipulator.
(1) Turn ON the Controller while the safety door is open in order to boot the controller
(2) Make sure that "Safety" is displayed on the main window status bar.
(3) Close the safety door, and turn ON the switch connecting to the latch release input.
The information that the safety door is open can be latched by software based on the latch
release input condition. To cancel the condition, close the safety door, and then close the
safety door latch release input.
Open
Closed : The latch release switch does not latch the condition that the safety door is open.
The latch release input also functions to acknowledge the change of to TEACH mode.
NOTE
In order to change the latched condition of TEACH mode, turn the mode selector key
switch on the Teach Pendant to "Auto". Then, close the latch release input.
54
software.
Make sure that the "Safety" is dimmed on the status bar.
: The latch release switch latches the condition that the safety door is open.
RC700 / RC700-A Rev.23

Hide quick links:

Advertisement

Table of Contents
loading

This manual is also suitable for:

Rc700-a

Table of Contents