Connection Of Development Pc And Controller With - Epson RC700-D Manual

7.4 Connection of Development PC and Controller with

Ethernet
Connection between the development PC and the Controller is shown below.
(1) Connect the development PC and the Controller using the Ethernet cable.
(2) Turn ON the Controller.
(3) Start EPSON RC+ 7.0.
(4) Display the [PC to Controller Communication] dialog from [Setup] in EPSON RC+
(5) Click the <Add> button.
(6) Connection "No.2" is added. Set the following and click the <Apply> button.
(7) [Name] and [IP Address] specified in procedure (6) is displayed.
RC700-D Rev.2
7.0 menu.
Name : Valid value to identify the Controller to connect
IP Address : IP address for Controller to connect
Functions 7. LAN (Ethernet Communication) Port
105