Setup & Operation 14. Option Slots
14.7 Force Sensor I/F Board
14.7.1 About Force Sensor I/F Board
You need to mount the Force Sensor I/F board in the option slot to communicate with the
Force Sensor I/F board has one port for the connector to connect to Force Sensor and only
one board is available.
When using the Force Sensor I/F board, one board expansion is available for RS-232C
Force Sensor can connect to all S250 series.
14.7.2 Board Configuration (Force Sensor I/F Board)
CN3 is all open.
Switch and Jumper Configuration
Do not change the following DSW1,
DSW2, and JMP1 configurations.
RC700 / RC700-A Rev.23