Neighbor Soft-Reconfiguration Inbound - Dell S4810 Reference Manual

neighbor soft-reconfiguration inbound

Enable soft-reconfiguration for BGP.
S4810
Syntax
neighbor {ip-address | peer-group-name} soft-reconfiguration
inbound
To disable, use the no neighbor {ip-address | peer-group-name} soft-
reconfiguration inbound command.
Parameters
ip-address
peer-group-
name
Defaults Disabled
Command ROUTER BGP
Modes
Command
This guide is platform-specific. For command information about other platforms,
History
refer to the relevant Dell Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version 9.0.2.0
Version
8.3.19.0
Version 8.3.11.1
Version 8.3.7.0
Version 7.8.1.0
Version 7.7.1.0
Version 7.4.1.0
Usage
This command enables soft-reconfiguration for the BGP neighbor specified. BGP
Information
stores all the updates the neighbor receives but does not reset the peer-session.
You cannot set this configuration for a peer that is associated with a peer group.
Similarly, you cannot associate a peer to a peer group if that peer is already
configured with these settings.
440
Enter the IP address of the neighbor in dotted decimal
format.
Enter the name of the peer group to disable or enable all
routers within the peer group.
Introduced on the S6000.
Introduced on the S4820T.
Introduced on the Z9000.
Introduced on the S4810.
Introduced on the S-Series.
Introduced on the C-Series.
Introduced.
CAUTION: Inbound update storage is a memory-intensive operation. The
entire BGP update database from the neighbor is stored in memory
regardless of the inbound policy results applied on the neighbor.
Border Gateway Protocol