Neighbor Soft-Reconfiguration Inbound - Dell Force10 S4810P Reference Manual

Usage
Peers that are enabled within a peer group are disabled when their peer group is disabled.
Information
The neighbor shutdown command terminates all BGP sessions on the BGP neighbor or
BGP peer group. Use this command with caution as it terminates the specified BGP sessions.
When a neighbor or peer group is shutdown, use the show ip bgp summary command to
confirm its status.
Related
show ip bgp summary
Commands
show ip bgp neighbors

neighbor soft-reconfiguration inbound

Enable soft-reconfiguration for BGP.
C-Series, E-Series, S-Series, Z-Series, S4810
Syntax neighbor {ip-address | peer-group-name} soft-reconfiguration
inbound
To disable, use the no neighbor {ip-address | peer-group-name} soft-
reconfiguration inbound command.
Parameters
ip-address
peer-group-name
Defaults Disabled
Command Modes ROUTER BGP
Command History
Version 8.3.11.1
Version 8.3.7.0
Version 7.8.1.0
Version 7.7.1.0
Version 7.4.1.0
Usage
This command enables soft-reconfiguration for the BGP neighbor specified. BGP stores all the
Information
updates received by the neighbor but does not reset the peer-session.
Related show ip bgp neighbors
Commands
– displays the current BGP configuration.
– displays the current BGP neighbors.
Enter the IP address of the neighbor in dotted decimal format.
Enter the name of the peer group to disable or enable all routers
within the peer group.
Introduced on the Z9000.
Introduced on the S4810.
Introduced on the S-Series.
Introduced on the C-Series.
Introduced.
CAUTION: Inbound update storage is a memory-intensive operation. The entire BGP
update database from the neighbor is stored in memory regardless of the inbound policy
results applied on the neighbor.
NOTE: This command is supported in BGP Router Configuration mode for IPv4 Unicast
address only.
– displays routes received by a neighbor.
399