Set Metric - Dell S4810 Reference Manual

Related bgp default local-preference
Commands routes.

set metric

To assign a new metric to redistributed routes, configure a filter.
S4810
Syntax
set metric [+ | -] metric-value
To delete a setting, enter no set metric.
Parameters
+
-
metric-value
Defaults Not configured.
Command ROUTE-MAP
Modes
Command
This guide is platform-specific. For command information about other platforms,
History
refer to the relevant Dell Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version 9.0.2.0
Version
8.3.19.0
Version 8.3.11.1
Version 8.3.7.0
Version 8.1.1.0
Version 7.6.1.0
Version 7.5.1.0
pre-Version
6.1.1.0
Related
set automatic-tag
Commands
set level
set metric-type
Access Control Lists (ACL)
— changes the default LOCAL_PREF attribute for all
(OPTIONAL) Enter + to add a metric-value to the
redistributed routes.
(OPTIONAL) Enter - to subtract a metric-value from the
redistributed routes.
Enter a number as the new metric value. The range is from
zero (0) to 4294967295.
Introduced on the S6000.
Introduced on the S4820T.
Introduced on the Z9000.
Introduced on the S4810.
Introduced on the E-Series ExaScale.
Introduced on the S-Series.
Introduced on the C-Series.
Introduced on the E-Series.
— computes the tag value of the route.
— specifies the OSPF area for route redistribution.
— specifies the route type assigned to redistributed routes.
291