Access Control Lists (ACL)
Access control lists (ACLs) are supported by the Dell Force10 operating software (FTOS) on all E-Series, C-Series, S-
Series, Z-Series, or S4810 platforms.
FTOS supports the following types of ACL, IP prefix list, and route maps:
•
Commands Common to all ACL Types
•
Common IP ACL Commands
•
Standard IP ACL Commands
•
Extended IP ACL Commands
•
Common MAC Access List Commands
•
Standard MAC ACL Commands
•
Extended MAC ACL Commands
•
IP Prefix List Commands
•
Route Map Commands
•
AS-Path Commands
•
IP Community List Commands
NOTE: For ACL commands that use the Trace function, refer to the Trace List Commands section in the
chapter.
NOTE: For IPv6 ACL commands, refer to
Commands Common to all ACL Types
The following commands are available within each ACL mode and do not have mode-specific options. Some commands
in this chapter may use similar names, but require different options to support the different ACL types (for example, the
deny and permit commands).
remark
Enter a description for an ACL entry.
C-Series, E-Series, S-Series, Z-Series, S4810
remark [remark-number] [description]
Syntax
Parameters
remark-number
IPv6 Access Control Lists (IPv6
Enter the remark number. The range is 0 to 4294967290.
NOTE: You can use the same sequence number for the remark
and an ACL rule.
ACLs).
7
Security
233