Machine Type Parameters [M8] - Mitsubishi Electric M800 Series Manual

M800/M80/E80/C80 Series Alarm/Parameter Manual
16 Machine Parameters

16.26 Machine Type Parameters [M8]

(PR) #12621 machine type
[M8]
Select the type of lathe: horizontal or vertical.
0: Horizontal-type lathe
1: Vertical-type lathe
(PR) #12622 turret move dir
[M8]
Select the linear axis direction to move the turret along for each part system.
Horizontal-type lathe (right-handed)
1: Front upper position
2: Front lower position
3: Rear upper position
4: Rear lower position
Horizontal-type lathe (left-handed)
11: Front upper position
12: Front lower position
13: Rear upper position
14: Rear lower position
Vertical-type lathe (right-handed)
21: Front left position
22: Front right position
Vertical-type lathe (left-handed)
31: Front left position
32: Front right position
(Note) Upper/lower position of horizontal-type lathe and right/left position of vertical-type lathe are the names
indicating the turret position with general machine configuration.
Select a number corresponding to the actual machine configuration and the axis direction to this param-
eter.
Axis configuration follows the base axis I, J, K (parameters #1026 to #1028).
(PR) #12623 tool rot ax para
[M8]
Select which of the following parameters to use as tool rotation axis-related parameters: Rotary axis config-
uration parameters or 3D check parameters.
0: Rotary axis configuration parameters
1: 3D check parameters
(PR) #12624 tool rot ax name
[M8]
Specify the name of tool rotation axis using the 2nd axis name.
---Setting range---
Two alphanumeric characters (A to Z and 1 to 9)
Select machine type (For L system only)
Select turret move direction (For L system only)
Select tool rotation axis parameters (For L system only)
Tool rotation axis name (For L system only)
685 IB-1501279-H