Mitsubishi Electric M800 Series Manual page 427

M800/M80/E80/C80 Series Alarm/Parameter Manual
16 Machine Parameters
(PR) #1256 set28
bit0: Switch to C axis mode at cancel of EMG stop/door open under spindle C axis
Select whether to switch the control to C axis mode when you execute and cancel emergency stop, or turn
ON and OFF the door open signal under spindle C axis control mode.
(This takes effect when spindle/C axis switch method is PLC signal type.)
0: Not switch to C axis mode.
Control is switched to C axis mode when C axis' Servo OFF signal is turned OFF and ON after cancel
of emergency stop or door open.
1: Switch to C axis mode when emergency stop or door open is cancelled.
bit1: Position loop gain in C axis zero return/orientation/synch tap zero return
[M8]
Select the position loop gain to be applied when the interpolation mode is selected for the spindle C axis,
spindle orientation or synchronous tap zero return that is executed when the spindle stops (when "#3106
zrn_typ/bitE"="0").
0: SP003 PGS
1: SP002 PGN
[C80]
Not used.
bit2: Change current FB (load) output unit
[M8]
Select the units in which the current FB (load) is output to a register.
When output in units of 0.01%, the output range is from 0 to 327.67%.
0: Default (Output in units of 1%).
1: Output in units of 0.01%.
[C80]
Not used.
bit3: Tool shape compensation in 3D coordinate conversion mode (For L system only)
[M8]
Select whether to apply tool shape compensation before or after executing 3D coordinate conversion.
0: Apply tool shape compensation before 3D coordinate conversion
1: Apply tool shape compensation after 3D coordinate conversion
[C80]
Not used.
#1257 set29
Not used. Set to "0".
IB-1501279-H 410