Mitsubishi Electric M800 Series Manual page 585

M800/M80/E80/C80 Series Alarm/Parameter Manual
16 Machine Parameters
(PR) #3150 spsscfeed6
[M8]
Set the observation speed, which is at the machine end, in the multi-step speed monitor.
(Note) When the setting value is larger than 18000, the last 2 digits will be ignored.
Ex. 1234567 -> 1234500(deg/min)
---Setting range---
0 to 6553500 (deg/min)
[C80]
Not used.
(PR) #3151 spsscfeed7
[M8]
Set the observation speed, which is at the machine end, in the multi-step speed monitor.
(Note) When the setting value is larger than 18000, the last 2 digits will be ignored.
Ex. 1234567 -> 1234500(deg/min)
---Setting range---
0 to 6553500 (deg/min)
[C80]
Not used.
(PR) #3152 spsscfeed8
[M8]
Set the observation speed, which is at the machine end, in the multi-step speed monitor.
(Note) When the setting value is larger than 18000, the last 2 digits will be ignored.
Ex. 1234567 -> 1234500(deg/min)
---Setting range---
0 to 6553500 (deg/min)
[C80]
Not used.
#3153 cms1
Set a viscous friction coefficient for spindle.
This parameter is to estimate the cutting torque of spindle.
#13018(SP018)/bit5=0: Mechanical gear 1-step
#13018(SP018)/bit5=1: Coil changeover H
---Setting range---
0 to ± 9999999 (0.00001%/rpm)
#3154 cms2
Set a viscous friction coefficient for spindle.
This parameter is to estimate the cutting torque of spindle.
#13018(SP018)/bit5=0: Mechanical gear 2-step
#13018(SP018)/bit5=1: Coil changeover L
---Setting range---
0 to ± 9999999 (0.00001%/rpm)
IB-1501279-H
Observation speed 6
Observation speed 7
Observation speed 8
Spindle viscous friction coefficient 1
Spindle viscous friction coefficient 2
568