Mitsubishi Electric M800 Series Manual page 401

M800/M80/E80/C80 Series Alarm/Parameter Manual
16 Machine Parameters
#1107 Tllfsc
Set the number of groups to be displayed on the tool life management II (L system) screen.
0: Displayed group count 1, maximum number of registered tools: 16
1: Displayed group count 2, maximum number of registered tools: 8
2: Displayed group count 4, maximum number of registered tools: 4
#1108 TlrectM
Set the M code for tool life management II (L system) re-count.
---Setting range---
0 to 99
(PR) #1112 S_TRG
Select the enable conditions for the user macro interrupt signal (UIT).
0: Enable when interrupt signal (UIT) turns ON
1: Enable when interrupt signal (UIT) is ON
(PR) #1113 INT_2
Select the performance after user macro interrupt signal (UIT) input.
0: Execute interrupt program without waiting for block being executed to end
1: Execute interrupt program after completing block being executed
#1114 mcrint
Select whether to clear statements other than specified arguments by macro call.
Also select whether to clear local variables by power-ON and resetting.
0: Clear the non-specified arguments by macro call.
1: Hold non-specified arguments by macro call
2: Hold non-specified arguments by macro call, and clear local variables by power-ON and resetting
#1115 thwait
Set the number of waits for retract when chamfering is OFF in thread cutting.
---Setting range---
0 to 99 (Approx. 4 ms)
Standard setting value: 4
#1116 G30SLM
Enable this function when disabling the soft limit check function at the second to fourth reference position
return.
0: Enable soft limit function
1: Disable soft limit function
(PR) #1117 H_sens
Not used.
#1118 mirr_A
Select one of the following two methods:
- Set the current length of tools on each facing turret.
- Set a value, assuming that the tools on each facing turret are in the same direction as that of those on the
base turret.
0: Current length of the tools on each facing turret
1: Value, assuming that the tools on each facing turret are in the same direction as that of those on the
base turret
#1119 Tmiron
Select whether to enable the mirror image of each facing turret with the T command.
0: Disable
1: Enable
IB-1501279-H
Split life management display screen (for L system on-
ly)
Life management re-count M code (for L system only)
Validate status trigger method
Validate interrupt method type 2
Macro argument initialization
Waiting for retract
Invalidate soft limit (manual operation)
Select how to set up the length of tools on cutter tables
(opposed tables) (for L system only)
Select the mirror image of each facing turret with T com-
mand (for L system only)
384