Aux Ax Dog Overrun; Aux Ax R-Pnt Direction Illegal; Aux Ax External Interlock; Aux Ax Internal Interlock - Mitsubishi Electric M800 Series Manual

Hide thumbs Also See for M800 Series:
Table of Contents

Advertisement

M800/M80/E80/C80 Series Alarm/Parameter Manual
1 Operation Errors (M)
1Operation Errors (M)
M00

Aux ax dog overrun

Details
When executing dog-type reference position, the zero point return speed is too fast or the dog length is too
short.
Remedy
Lower the zero point return speed or increase the dog length.
M00

Aux ax R-pnt direction illegal

Details
When executing reference position return, the axis was moved in the opposite of the designated direction.
Remedy
Move the axis in the correct direction.
M00

Aux ax external interlock

Details
The axis interlock function is valid.
Remedy
Cancel the interlock signal.
M00

Aux ax internal interlock

Details
An interlock was established by the servo OFF function.
Remedy
Cancel the servo OFF.
M00
Aux ax soft limit
Details
The stored stroke limit was reached.
Remedy
Check the stored stroke limit setting and machine position.
M00
Aux ax R ret invld at abs alm
Details
Reference position return was executed during an absolute position alarm.
Remedy
Initialize the absolute position reference point and then fix the absolute position coordinates.
M00
Aux ax R ret invld at ini
Details
Reference position return was executed during absolute position initial setting.
Remedy
Initialize the absolute position reference point and then fix the absolute position coordinates.
M01
Dog overrun
Details
When returning to the reference position, the near-point detection limit switch did not stop over the dog, but
overran the dog.
Remedy
Increase the length of the near-point dog.
Reduce the reference position return speed.
IB-1501279-H
4
0001
0003
0004
0005
0007
0024
0025
0001

Hide quick links:

Advertisement

Table of Contents
loading

This manual is also suitable for:

C80 seriesM80 seriesE80 series

Table of Contents