Mitsubishi Electric M800 Series Manual page 496

M800/M80/E80/C80 Series Alarm/Parameter Manual
16 Machine Parameters
#2097 tlml2-
Set the sensor position (on sub side) in the (-) direction when using the tool setter on the sub spindle side.
(Note) In the case of the basic axis and inclined axis of the inclined axis specifications, set the position on
the orthogonal coordinate.
---Setting range---
-99999.999 to 99999.999 (mm)
#2098 tlml2+
Set the sensor position (on sub side) in (+) direction when using the tool setter on the sub spindle side.
(Note) In the case of the basic axis and inclined axis of the inclined axis specifications, set the position on
the orthogonal coordinate.
---Setting range---
-99999.999 to 99999.999 (mm)
#2102 skip_tL
Set a linear control time constant for variable speed skip acceleration and deceleration, or for an occasion
where a skip command issues acceleration/deceleration time constant enabled (R1).
The time constant will be enabled when LC (cutting feed with linear acceleration and deceleration) or "F" (soft
acceleration/deceleration) is selected in "#2003 smgst Acceleration and deceleration modes".
When set to "0", the time constant set by "#2008 G1t1" is used.
---Setting range---
0 to 4000 (ms)
#2103 skip_t1
Set a primary-delay time constant for variable speed skip acceleration and deceleration, or for an occasion
where a skip command issues acceleration/deceleration time constant enabled (R1).
The time constant will be enabled when C1 (cutting feed with primary delay) or C3 (exponential acceleration
and linear deceleration) is selected in "#2003 smgst Acceleration and deceleration modes". When the soft
acceleration/deceleration is selected, the second-step time constant will be used.
When set to "0", the time constant set by "#2008 G1t1" is used.
---Setting range---
0 to 5000 (ms)
#2106 Index unit
Set the indexing unit to which the rotary axis can be positioned.
---Setting range---
0 to 360 (°)
#2109 Rapid (H-precision)
Set the rapid traverse rate for each axis in the high-accuracy control mode. "#2001 rapid" will be used when
"0" is set.
---Setting range---
0 to 1000000 (mm/min)
#2110 Clamp (H-precision)
Set the cutting feed maximum speed for each axis in the high-accuracy control mode. "#2002 clamp" will be
used when "0" is set.
---Setting range---
0 to 1000000 (mm/min)
#2111 Blf valid
Set whether to enable the quadrant protrusion compensation.
0: Disable
1: Enable
If either of "#2112 Blf motor inertia", "#2115 Blf motor stl trq" or "#2113 Blf visc friction" is set to "0", quadrant
protrusion compensation will not work even if this parameter is set to "1".
Sub side tool setter - direction sensor
Sub side tool setter + direction sensor
Skip time constant linear
Skip time constant primary delay / Second-step time
constant for soft acceleration/deceleration
Indexing unit
Rapid traverse rate for high-accuracy control mode
Cutting feed clamp speed for high-accuracy control
mode
Quadrant protrusion compensation valid
479 IB-1501279-H