Restart Switch On; Program Check Mode; Cycle St. In Buffer Correct; In Reset Process - Mitsubishi Electric M800 Series Manual

M800/M80/E80/C80 Series Alarm/Parameter Manual
1 Operation Errors (M)
M01

Restart switch ON

Details
Restart switch has been turned ON and manual mode has been selected before the restart search is complet-
ed.
Remedy
Search the block to restart.
Turn the restart switch OFF.
M01

Program check mode

Details
The cycle start button was pressed during program check or in program check mode.
Remedy
Press the reset button to cancel the program check mode.
M01

Cycle st. in buffer correct

Details
The cycle start button was pressed during buffer correction.
Remedy
Press the cycle start button after the buffer correction is completed.
M01

In reset process

Details
The cycle start button was pressed during resetting or tape rewinding.
Remedy
When rewinding the tape, wait for the winding to end, or press the reset button to stop the winding, and
then press the cycle start button.
During resetting, wait for the resetting to end, and then press the automatic start button.
M01 Playback not possible
Details
The playback switch was turned ON during editing.
Remedy
Cancel the editing by pressing the input or previous screen key before turning ON the playback switch.
M01 Turn stop in normal line cntrl
Details
The turning angle at the block joint exceeded the limit during normal line control.
In normal line control type I:
The parameter "#1523 C_feed" (Normal line control axis turning speed) has not been set.
In normal line control type II:
When turning in the inside of the arc, the set value for the parameter "#8041 C-rot. R" is larger than the arc
radius.
Remedy
Correct the program.
Correct the parameter "#1523 C_feed" (Normal line control axis turning speed) setting.
Correct the parameter "#8041 C-rot. R" setting.
M01 Reverse run impossible
Details
Any of the following conditions are occurring.
a) There is no block to run backward
b) Eight blocks without a travel command continued
Remedy
Execute forward run to clear the alarm.
Reset to clear the alarm.
IB-1501279-H 12
0111
0112
0113
0115
0117
0118
0119