R Comp Select; Host Link; G71/G72 Pocket; Milling Radius - Mitsubishi Electric M800 Series Manual

M800/M80/E80/C80 Series Alarm/Parameter Manual
15 User Parameters
#8108

R COMP Select

Select the arc radius error compensation target.
0: Perform compensation over all axes.
1: Perform compensation axis by axis.
(Note) This parameter is effective only when "#8107 R COMPENSATION" is "1".
#8109

HOST LINK

[M8]
Select whether to enable computer link B instead of the RS-232C port.
0: Disable (Enable normal RS-232C communication.)
1: Enable (Disable normal RS-232C communication.)
[C80]
Not used.
#8110

G71/G72 POCKET

Select whether to enable the pocket machining when there is a dimple (pocket) in the rough cutting cycle
(G71, G72) finishing program.
0: OFF
1: ON
#8111

Milling Radius

Select the diameter and radius of the linear axis for milling (cylindrical/pole coordinate) interpolation.
0: All axes radius command
1: Each axis setting (follows "#1019 dia")
(Note) This parameter is valid only in the milling (cylindrical/polar coordinate) interpolation mode.
#8112 DECIMAL PNT-P
Select whether to enable the decimal point command for G04 address P.
0: Disable
1: Enable
#8113 Milling Init G16
Set which plane to execute for milling machining after the power is turned ON or reset.
#8113:0, #8114:0 ---> G17 plane
#8113:0, #8114:1 ---> G19 plane
#8113:1, #8114:0 ---> G16 plane
#8113:1, #8114:1 ---> G16 plane
0: Not G16 plane
1: G16 plane
(Note) This parameter is valid for the G code system 2, 3, 4 or 5 ("#1037 cmdtyp"="3", "4", "5" or "6").
IB-1501279-H 222