Illegal Addr In 3D Coord Blk; Travel Cmd Error In 3Dconvert; End Point Err In 3D Conversion; No Spec: Tool Axis Compen - Mitsubishi Electric M800 Series Manual

M800/M80/E80/C80 Series Alarm/Parameter Manual
12 Program Errors (P)
P923

Illegal addr in 3D coord blk

Details
A G code and G68 was commanded in a block though the G code cannot be commanded with G68.
Remedy
Refer to the programming manual for usable G commands.
P924

Travel cmd error in 3Dconvert

Details
An incorrect travel command has been given during the 3D coordinate conversion mode.
Remedy
Correct the program.
P925

End point err in 3D conversion

Details
The end point of a travel command given during G68.1 ,E1 is not on the tool path.
Remedy
Correct the program.
P930

No spec: Tool axis compen

Details
A tool length compensation along the tool axis command was issued though it is out of specifications.
Remedy
Check the specifications.
P931 Executing tool axis compen
Details
There is a G code that cannot be commanded during tool length compensation along the tool axis.
Remedy
Correct the program.
P932 Rot axis parameter error
Details
There is an illegal orthogonal axis name or rotary axis name set in the rotary axis configuration parameters.
There is an illegal setting in the parameter concerning the configuration of the inclined surface machining axis.
Remedy
Set the correct value and turn the power ON again.
P934 5-axis control config. error
Details
The function cannot be executed under the axis configuration of the part system.
The rotary axis is in the spindle mode of the spindle position control.
Remedy
Correct the program.
Check and correct the rotary axis configuration parameters so that the function can be executed in the axis
configuration.
P940 No spec: Tool tip control
Details
There is no specification for tool tip center control.
Remedy
Check the specifications.
157 IB-1501279-H