Synchronous Tap Error; No Pitch/Thread Number; Pitch/Thread Number Error; No Spec: Sync Tapping Cycle - Mitsubishi Electric M800 Series Manual

M800/M80/E80/C80 Series Alarm/Parameter Manual
12 Program Errors (P)
P182

Synchronous tap error

Details
Connection to the main spindle unit was not established.
The synchronous tapping was attempted with the spindle not serially connected under the multiple-spindle
control I.
Synchronous tapping command was given to the analog spindle while analog spindle synchronous tapping
was unavailable.
Remedy
Check connection to the main spindle.
Check that the main spindle encoder exists.
Set 1 to the parameter #3024 (sout).
Correct the program.
P183

No pitch/thread number

Details
The pitch or number of threads has not been commanded in the tap cycle of a fixed cycle for drilling command.
Remedy
Specify the pitch data and the number of threads by F or E command.
P184

Pitch/thread number error

Details
The pitch or the number of threads per inch is illegal in the tap cycle of the fixed cycle for drilling command.
The pitch is too small for the spindle rotation speed.
The thread number is too large for the spindle rotation speed.
Remedy
Correct the pitch or the number of threads per inch.
P185

No spec: Sync tapping cycle

Details
Synchronous tapping cycle (G84/G74) was commanded though it is out of specifications.
Remedy
Check the specifications.
P186 Illegal S cmnd in synchro tap
Details
S command was issued during synchronous tapping modal.
Remedy
Cancel the synchronous tapping before issuing the S command.
P190 No spec: Turning cycle
Details
A lathe cutting cycle command was issued though it is out of specifications.
Remedy
Check the specification.
Delete the lathe cutting cycle command.
P191 Taper length error
Details
In the lathe cutting cycle, the specified length of taper section is illegal.
Remedy
Set the smaller radius value than the axis travel amount in the lathe cycle command.
P192 Chamfering error
Details
Chamfering in the thread cutting cycle is illegal.
Remedy
Set a chamfering amount not exceeding the cycle.
135 IB-1501279-H