3D Machine Interference/No Machine Model; 3D Machine Interference/Machine Model Illegal; 3D Machine Interference Check Load Excess; 3D Machine Interference Check Error - Mitsubishi Electric M800 Series Manual

M800/M80/E80/C80 Series Alarm/Parameter Manual
5 System Alarms (Z)
Z69 External link error
Details
The I/O No. designated in the FROM/TO instruction is different from the mounted location of the intelligent func-
tion module on the extension base (the module's I/O No.).
Remedy
Correct the I/O No. Then turn the CNC's power ON again.
Z82

3D machine interference/No machine model

Details
Machine model is not registered.
Remedy
Press RESET to cancel the alarm.
Movement can be resumed after the cancellation. However, the 3D machine interference check will become
invalid.
Inform the machine tool builder if an alarm occurs.
Z82

3D machine interference/Machine model illegal

Details
Machine model is illegal.
Remedy
Press RESET to cancel the alarm.
Movement can be resumed after the cancellation. However, the 3D machine interference check will become
invalid.
Inform the machine tool builder if an alarm occurs.
Z82

3D machine Interference check load excess

Details
The calculation of the interference check took time and caused a deceleration.
Remedy
Inform the machine tool builder.
Restart the axis in case of a manual operation.
In case of an automatic operation, the operation will automatically resume when the processing load of the
interference check decreases.
Z82

3D machine Interference check error

Details
The interference check failed.
Remedy
Take a note of the failed status and contact the service center.
Press RESET to cancel the alarm. Invalidate the 3D machine interference check to continue the operation.
Z84 Unable to save all the history
Details
The system is unable to store the data due to lack of free space on the internal memory.
Remedy
Ensure sufficient free space on the internal memory.
Z85 OP panel I/O not connected
Details
Failed to recognize the connection between the NC unit and operation panel I/O unit.
Remedy
Make sure an operation panel I/O unit is connected.
Make sure an operation panel I/O unit is supplied with power.
Check for disconnection of the cable between the NC unit and operation panel I/O unit.
*If you connect no operation panel I/O unit to the NC unit, set the parameter "#1261 set33/bit1" to "1"."
11
0001
0002
0003
0004
0001
91 IB-1501279-H